Digital Microwave Barriers BM 120 HP VAC AVS Electronics

Bunker perimeter solution description: 

The Digital Microwave Barriers BM 120 HP VAC  are reliable intrusion detectors used for outdoor perimeter intrusion protection. VAC series are directly fed by the main power supply and include an optional backup battery to compensate an electricity absence. Main power feeding simplifies the wiring and decrease the installation cost.

BM is composed of 2 units – 1 transmitter (TX) and 1 receiver (RX) - installed at a maximum distance of 120 meters. The transmitter emits continuously microwaves in direction of the receiver. When an intruder passes between the two units, the received signal is reduced consecutively and on reaching the alarm level the alarm is generated. In addition, these barriers allow to detect and signal an accidental and permanent interruption of the beam.

BMs integrate planar antennas which reduce of 20% the sensibility area compared to former parabolic antennas. Longer distances BM can be installed for the same perimeters and costs are saved. In addition, to be protected from rain, the parabolic antennas use big expansive difficult-to-handle waterproof housings when the BM’s planar antennas are highly protected by tropicalizing resins and installed in high resistant protective cover that avoid the condensation and its consecutive rust development.

These microwave barriers are placed in containers specially designed to tolerate and facilitate even the most deilicate installations. They operate in all weather conditions (snow, rain, fog) without distances reduction, unlike the active infrared barriers. If the temperature reaches less than -5°C, it is possible to place a TERM1 heating kit. BM temperature range is -20/+55°C.

Microwave Barriers BM 120 HP VAC - AVS Electronics
Bunker perimeter security sensor reference: 

BM 120 HP VAC

Bunker perimeter solution features: 
  • AUTOMATIC GAIN CONTROL (AGC); The environmental variations may improve or deteriorate the microwaves level reception over time. An Automatic Gain Control circuit automatically optimizes the level to maintain it flat: the settings are easier, the security is higher. 
  • REDUCTION OF THE SENSIBILITY AREA: BM HP may reduce digitally of up to 30% the area of sensibility and then ignore the movements in the peripheral objects (i.e. from fences or trees) which are the origin of unwanted alarms. 
  • FALSE ALARM FILTER: BM HP barriers records automatically up to 3600 events it is possible to classify between good and false alarms. BM HP verifies then the new events according to this database and stop the unwanted alarms. 
  • DIGITAL INTERFACE: Additionally to the NC outputs and other regular settings, BM HP present a USB and a RS485 port to be coupled to a RS485 hub or an AVS ELECTRONICS’ control panel.
  • SOFTWARE: Thanks to the local USB port or remotely by PSTN, GSM or IP, HPWIN software shows all the parameters, an oscilloscope, the 3600 last alarm events (with date and time) and proposes all the tools to set the barriers.
Specifications: 
  • MW range: up to 120 meters
  • Separate outputs for alarm, disqualification and tamper
  • Additional input for outdoor detectors
  • RS485 connection to XTREAM and XSATHP
  • USB connection directly to a PC
  • Complete management by PC via HPWIN software
  • Alarms memory
  • False alarm filter
  • Consumption: 130mA (TX+RX)
  • Power supply: 230Vac
  • Dimensions (LxHxD): 136 x 225 x 225mm
  • Housing: plastic box with inside adjustment
Number of beams: 
2
Bunker perimeter solution type: 
Download documentation on perimeter detection product: 
Trademark: 
Accessories: 

REFERENCE

ACCESSORIES

BAT BM

Single optional backup battery for BM XX HP VAC barrier

AMP

Single "vertical tamper" kit for BM microwave barriers

SB 120

120cm floor standing pole for BM microwave barriers (Ø4cm)

SB 130

130 cm buried pole for BM microwave barriers (Ø4cm)

SB 20

20 cm wall mounting pole for BM microwave barriers (Ø4cm)

SB 60

60 cm wall mounting pole for BM microwave barriers (Ø4cm)

TERM 1

12 Vdc heating kit for BM M and BM HP microwave barriers

I40-40

40cm buried pole (Ø4cm) (single unit)

I120-40

120cm buried pole for BM microwave barriers (Ø4cm) (pair)

I150-40

150cm buried pole for BM microwave barriers (Ø4cm) (pair)